Devins 98 Limited

Those look nice. Maybe I should finally get a new pair of front links since I haven't had any for the last six months....lol

offroad_medic wrote:Those look nice. Maybe I should finally get a new pair of front links since I haven't had any for the last six months....lol

Then you are going to have to wait until August. I think i was his last one as i believe he is going to be gone for awhile. Not sure though. I just remember him telling me he was going to be done making them for awhile cause he had some stuff going on... They dont really seem like they would be too hard to fab up though. If you wanna come by we could take a look and see exactly what you would need to make your own? Minimal welding it looks like and then just knowing where to get the parts and whatnot.

Looking good man! Glad to see this coming out. We'll have to get a trail run set up soon.

So went wheelin today with some buddies and ran into a little bit of a problem... Could not for the life of me get the front disconnects off to test out not having the sway bar connected... so i may just unhook them until i take it on road trips or whatever then put them back on. So i just left them on and well i rubbed a ton today! so time to figure out where and get that fixed now. But anyways here are some pics from today...













So on top of all of teh crap i found out today my cb also isnt working both ways... i can hear others just fine, but they cant hear me... I tried 2 different mics so i dont think its the mic... so its either gotta be the tuning, or the cb itself that isnt putting out the signal right. I am not too sure. anyone with cb expertise feel free to comment on what the issue might be! The help would be much appreciated... Aaaaannnnddddd also i got pulled over for no mud flaps on the way home lol. So those will be getting made probably this week so that i can remove them when im wheeling as well.

Did you try a big hammer to get the discos off??

Yes i did... they wouldnt slide down... Really weird. But i messaged the guy on t4r today as well to see if there was a specific way to take them off or not. Basically, i could get the pins out and the discos out. But then they would not slide down and off like they should have. So i just kept them on for today. Kinda bugged about it, but im not really sure as to if i need to take a wrench to them to take them off and back the bottom pin out or what in order for them to drop down and out. Kinda frustrating but i guess we will see what he says the issue is or if there is a specific way to take them off too when i finally hear back from him.

So When are we going to start building the other rig? Lets get some won tons and throw it on leafs! It's cheap and easy, and great until you can afford a linked setup!